![]() The LED will continue to blink every 2 seconds. The LED will blink once and then after 10 seconds it will initiate code The remote at the cable box ( not the TV). NOTE: this time DO NOT HOLD THE CC button down, just press and firmly hold down the button while pointing (If setting upĪ box that does not have a separate power button and is always on, see notes at the bottom of this page.) 7.If the channels are not changing properly make sure the TV is on and this time turn the cable box OFF. ![]() If the channels change correctly, make sure volume and TV power on and off work and if they do, youĪre done. Point the remote toward the cable box and TV and try the channel up and down buttons as well as the the channel Next, Hold Down the button and CC buttonĪt the same time and wait until the LED light blinks quickly 3 times. 6.To Program the Cable Box make sure the cable box and TV are on. StartĪgain at step #3, the code search will continue where it left off. If the power and volume keys are not working properly, you may not have an exact code match. If you accidentally changed the input on the TV, manually change it back from the TV's control panelĪnd then try power and volume buttons ONLY. If power and volume buttons work correctly on the remote then proceed to step #6. Now test the remote by pressing the TV Power button testing On/Off and then the VOLUME + /-, DO NOT PRESS CHANNEL +/- buttons as you may change input on TV. Remove your finger from the Setup button the code automatically locks in. The LED will blink once and then after 7 seconds Press and firmly Hold down the Setup button, do not release. ![]() It will not be necessary to point the remote at that exact area once Point the remoteĪt the CENTER of the front panel of the TV. Then stand back about 5 feet from the TV. 3.Turn on the TV and the Cable Box should also be on. ![]() It is important that after you set up the TV you don't change the channels until after you complete The second step will then be to program the cable box. INSTRUCTIONS FOR NEW CLEAN REMOTE CR3BCB THAT HAS BUTTON AT THE BOTTOM OF THE REMOTE If you do not have an individual cable box in each guest room, then turn sheet over to page 1 IF YOU HAVE A TV AND AN INDIVIDUAL CABLE BOX IN EACH GUEST ROOM, START HERE : 1.First step is to program the TV. You have now reset the code list back to the beginning. Setup button for 3 seconds and then while still pressing the Setup button down, press and hold theĬC button down at the same time until the red LED light blinks quickly 3 times, then release bothīuttons. Important Note: If you think you missed the code or are testing remote on differentīrand TV's: Reset the remote back to the beginning of the code search first press and hold the If the main functions are not working properly, TV shuts off immediately remove your finger from the Setup button the code automatically locks in.ģ. The LED will blink once and thenĪfter 7 seconds it will initiate code search. It will not be necessary to point the remote at that exact area once the remote isĢ. Turn on the TV and then stand back about 5 feet from TV and Point the remote at the CENTER of
0 Comments
Leave a Reply. |